EN
9
air washer AW 20 S
Disassembling the disk
1. Take the disk out of the water tank.
2. Open the lateral screwing with the Easy Kit or with a coin
by turning the cap counter-clockwise.
3. Remove the cap.
4. You can take the disks off the shaft and clean them
individually.
5. After cleaning, slide the disks back on the shaft.
6. Put the cap back on the shaft and fasten the cap by turning
clockwise.
7. Reinsert the disk into the device. Check the disk for
complete movability. If necessary, reposition the
SecoSan
®
Stick so that the disk can turn freely.
8. Put the upper part back on the device.
Cleaning the pre-filters
Clean the pre-filters regularly, at the latest when heavy soiling is
visible.
Proceed as follows to clean the pre-filters:
ü
The device is switched off and disconnected from the
mains.
1. Slightly press onto the air inlet louvre on both sides of the
device.
ð
The louvres open.
2. Fold out the louvres up to the lock position at 45°.
3. Remove the two pre-filters.
4. Clean the pre-filters under fresh water with a soft cloth.
5. Remove the two louvres by carefully pressing them down.
6. Clean the louvres under fresh water with a soft cloth.
7. Dry the pre-filters and the louvres before refitting them into
the device.
8. Reinsert the louvres into the guides and fold up the louvres
until they lock in place at approx. 45°.
9. Refit the pre-filters into the guide rail in the louvre.
10. Close the louvres with a snap.
