P5
5-3.Making electrical wire connection
The standard lead wire is 54" long.
You may need to cut all 5 lead wires (from motor) to proper length & strip them for wire connection
to make it easier for Canopy installation.
Follow diagram below and make sure that all exposed wires are secured inside wire nuts.
Note : Wires from house may vary in color. If the house wires do NOT include a ground wire (green)
AND the optional #600 LED Light Kit is being installed, to prevent flickering, this unit must be
grounded/earthed to the home’s ground/earth; please consult an electrician.
After wiring is completed, gently push wires into junction box with wire nuts pointing upward.
From Remote
From House
(AC-N)
(AC-L)
White
Black
From Fan
Black
White
Black
White
Gray
Black
White
Gray
(
For motor
)
(
For motor
)
(
For motor
)
Green
( house ground wire )
Green
Green
( from Hanger Ball )
( from mounting bracket )
Blue
Blue
(
For Light Kit
)
Orange
Orange
(
For Light Kit
)
(
For motor
)
(
For motor
)
(
For motor
)
(
For Light Kit
)
(
For Light Kit
)
“ Special note: All Green grounding wires, from Hanger ball/Mounting bracket/Receiver,
must be well attached to House Ground/Ear th to prevent flickering of LED. ”
*Transmitter
*Receiver
A
Set
B
Set
FC912RS
P13Y808082
For 3VG76
FC912RS
P13Y808082
1.REMOTE MODEL &
SERIAL NUMBER
2.FAN MODEL NUMBER
NOTICE
:
Many remote sets for DC fans look the same. This remote set is pre-paired and labeled at the factory, please note the
following before operation:
1a. The Remote Model Number on transmitter and receiver must be the same.
1b. The Remote Serial Number will be the same on a pre-paired remote set. If it is different, it will need to be paired
(See page 8)
2. The Fan Model Number label must be the same as the fan’s model number in front page (3VG76) for proper
operation.(There is no Fan Model Number on transmitter.)
3. Do not mix the remote sets if you are installing more than one fan.
3.Do
not
mix
5-2.Insert receiver into mounting bracket
NOTE:
Do not squeeze all the wires while inserting the receiver into the mounting bracket.
5. WIRE CONNECTION
5-1. Verify that serial Number & Model Number match on the Receiver and Transmitter
Receiver
Mounting Bracket
