6. CANOPY INSTALLATION
6-3.Key Hole (2)
6-3.Screw (2)
Canopy
6-5.Deco Ring
Note:
Two screws are installed on mounting
bracket for canopy installation.
6-1. Push canopy up until the two pre-screwed
screws on the mounting bracket are engaged
with the two key hole s on canopy.
6-2. Before rotating the canopy, make sure Key
hole
A
&
B
of the canopy correspond to
A
&
B
positions of the hanging bracket.
6-3. Rotate canopy slightly until the two pre-
installed screw heads are engaged in the narrow
end of key holes.
6-4.Tighten both screws.
6-5. Aligning the nubs from Deco Ring to 3 holes on
the canopy, push Deco Ring up and snap into the
canopy.
DIMMER< >ON
12V
DIMMER< >ON
7. REMOTE TRANSMITTER
ASSEMBLY
DIMMER< >ON
7-1. Install the battery
Remove the back cover and install the
12V battery. (Included from remote box)
7-2. Check the dip switch position
(Original dip switch is on Dimming position)
Set dip switch in
DIMMER
position for LED dimming.
Set dip switch in
ON
position for LED ON/OFF only.
7-3. Re-install the back cover.
12V
Turn on power at breaker box, the fan is ready for operation!
(The receiver will have Beep sound)
OFF
OFF
OFF
ON
6-1.Key hole
B
A
B
6-1.Key hole
A
A
B
B
Hanging
Bracket
Receiver
Canopy
6-1.
6-1.
A
P6
Back Cover
Back Cover
