TRONXY X5SA-400-2E, User Manual

Page: 29 / 32

25
4. If the first layer upwarp ?
1
）
Check that the hot bed has been leveled.
2
）
Check the surface of the hot bed for dirt.
3
）
Check whether the distance between the nozzle and the
platform is too high, resulting in insufficient adhesive force.
4
）
Check the hot bed for adequate temperature.
5
）
Check the first layer of the slicing software to see if it is
printing too fast.
5. The model is not easy to take off
？
1
）
Heating the hot bed to 50-70
℃
, and after cooling to try
again, or use the shovel.
2) It is recommended to buy TRONXY magnetic stickers.
6. Can't heat it up?
1
）
Check the heating rod and thermistor for poor contact or damage.
2) Check that the slice software has set the target temperature.
3) Check whether the thermistor wire falls off.
7. Motor out of step?
1
）
Check the tightness of the belt, whether the pulley is not
locked.
2
）
Check the current voltage.
3
）
Check X/Y/Z axis motion is smooth.
4
）
Print speed too fast.
5
）
Environment temp too high.
6
）
Need flash the firmware.
8. Abnormal motor noise or vibration?
1
）
Check whether the motor line is in bad contact, loose or
wrong connection.
2
）
Motor temperature is too high.
3
）
Check whether the motor is damaged.
4
）
Flash the firmware.
5
）
The printing load is too heavy.