TRONXY X5SA-400-2E, User Manual

Page: 24 / 32

20
Manual leveling
：
Click the four points of ABCD in the figure below, the print head will move
to the corresponding position, and then adjust the leveling nut M, so that
the interval between the nozzle and the platform is a piece of A4 paper.
After adjusting the four points in turn, it needs to be verified again. If the
interval is appropriate, the leveling is completed.
A
B
C
D
M
Auto leveling
：
①
Automatic leveling for automatic leveling version of the machine, the
manual version can not be use. Click the leveling function in the figure to
automatically pop up the interface, select "automatic leveling",jump out of
the figure (1) interface, and start leveling. After the Detection is completed,
the error value of each point will be displayed. If the value is greater than
0.5, adjust the leveling nut in the corresponding area, and then reset until
all values are less than 0.5, then the automatic leveling is completed
②
Then click “Z offset”, the print head will move to the middle of the platform,
observe the height of the nozzle and platform, and then click
①②，
make
the distance between the nozzle and platform for a piece of A4 paper
height, then click
③
, reset the zero, so that the end of leveling.
Figure
（
1
）
autolevel
③
①
②