TROUBLE SHOOTING
Before removing your Amplifier, refer to list below and follow suggested procedure. Speakers and
their wires should be tested first.
No Output:
a. Confirm that all terminal strip connections are firmly connected.
b. Check in-line and built-in fuses. Both “+12V” and “RMT” terminals must have +12Volts to chassis
ground.
c. Confirm that signal source (Car Radio/Deck, EQ, X-over etc.) is connected and is supplying output
signal.
To confirm that the Amplifier is working, connect an RCA patch cord to LEFT & RIGHT low-Level inputs
of Amplifier only (Do not connect the other end of the patch cord).
Briefly tap the center pin of each (disconnected) RCA plug on the other (disconnected) end with your
finger. This should produce a noise (feedback) in the speakers.
Only One Channel Works:
a. Confirm that speaker terminal strip connections are firmly connected.
b. Check “BALANCE” control on Car Stereo (or signal source) to verify is at mid-point.
c. If using RCA Low-Level inputs, reverse the input plugs at the Amplifier (right to left or vice versa).
If the channel that is silent reverses position, the problem is in the Car Stereo(EQ, X-over, or other
signal source) or connecting cable.
Weak Output
a. If noise is a “whine” that goes and down with engine speed, confirm that Amplifier and any other
source unit (Radio, EQ, X-over etc.) is properly grounded.
b. A “clicking” or “popping” noise at a rate that follows engine speed is generally induced by the vehicles ignition system.
Confirm that the vehicle is equipped with resistor plugs and plug wires. Or, ignition system may need
service.
c. Speaker and input wires should not be routed next to wires that interconnect lights and other
accessories/equipment.
d. If above steps do not improve/clear noise interference, the system should be checked by a professional mobile audio
installer.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your
local authorities or your dealer about the way to proceed. The specifications are typical. The actual values
can slightly change from one unit to the other. Specifications can be changed without prior notice.
WARRANTY CONDITIONS
The date the product leaves the importer is considered to be the date the warranty begins. Only companies approved by Tronios are
allowed to work on the equipment. During warranty period (defective) equipment must be returned to the dealer by pre-paid mail in the
original box. Potentiometers have a limited lifetime and are not covered by the manufacturer for more than normal use.
For all service enquiries, refer to your local distributor,as he is best able to help you.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. Tronios cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
