the Amplifier, and will remain inoperable until the condition that has caused the problem is corrected.
To reset, simply turn your radio “OFF” momentarily, and then turn “ON” again.
CAUTION: THIS AMPLIFIER IS DESIGNED TO OPERATE WITH A MINIMUM LOAD IMPEDANCE OF 2 OHMS IN
STEREO, 4 OHMS IN MONO (BRIDGED), OR 8 OHM IN MULTI-MODE (TRI-MODE) CONSTITUTE TO POTENTIAL
DAMAGE TO THE MOSFET POWER SUPPLY.
INPUT SENSITIVITY (LEVEL) CONTROLS
To be connected to a line driver, crossover or head unit via RCA cables. In order to achieve maximum
signal-to-noise performance, these controls adjust the signal level from your Car stereo/source, to
match the Amplifier’s sensitivity. It is NOT a volume control. It also can be controlled by a remote
controller. For location of controls.
To adjust, proceed as follows:
a. Set INPUT LEVEL controls at mid-point.
b. Listen for audible distortion as you increase the Car Stereo VOLUME control. If none is heard, turn
the adjustment level control toward “MAX” in stages, until the onset of audible distortion is heard,
then decrease to “MIN” level prior to the immediate point of audible distortion.
c. If distortion is immediately heard, turn control to “MIN” until the sound is clear. Adjust both controls
to approximately the same level.
NOTE: NOT PERFORMING ABOVE ADJUSTMENT PROCEDURE ANDIOR SIMPLY SETTING THESE CONTROLS
AT OR NEAR “MAX” POSITION.MAY INDUCE ELECTRICAL AUDIO NOISE INTO THE SYSTEM.
CONNECTING THE SPEAKERS
2 Channel Amplifier
STEREO MODE
MONO MODE
