10133-9
4. ASSEMBLY STEPS
STEP 1
• Attach two 50 x 50mm Square End Caps
(36) onto the Rear Base (2).
• Attach Main Base (1) and Connect Piece
(19) to Rear Base (2) using two 3/8” x 2-7/8”
Hex Bolts (66), four 3/8” Washers (77) and
two 3/8” Locknuts (73).
STEP 2
• Slide two Round Bumpers (45) down the
Guide Rods (4).
• Secure two Guide Rods (4) into the Rear
Base (2) using two 3/8” x 1” Hex Bolts (62)
and two 3/8” Washers (77).
• Slide Weight Base Plate (33) and Weight
Selection Rod (30) down the Guide Rods (4).
• Slide Top Plate (31) down the Guide Rods (4).
• Attach Plastic Bushing (86) to the top hole
of Weight Selection Rod (30) with Pin (57).
• Secure the Weight Selection Pin (34) to
the Weight Selection Rod (30) as shown.
• Attach Vertical Post (3) to Main Base (1)
using two 3/8” x 1” Hex Bolts (62) and two
3/8” Washers (77).
