Section 9 TROUBLESHOOTING
9-2
Message
“Place transparency in bypass.”
[“Place transparencies on stack
bypass.”]
“Check paper size.”
“Reposition original.”
“Check paper size. Copy paper is not
the same size as original.”
[“Paper size in cassette differs from
actual size. Check paper size in
cassette.”]
“Reposition original or change drawer.”
[“Reset original or select another paper
cassette.”]
“Reset originals in processor.”
“Reset all originals in processor.”
[“Reset originals in processor.”]
“Reset all originals in Document
processor.”
[“Reset originals in Document
processor.”]
“Cannot copy this paper type.”
“Cannot staple this paper type.”
“Cannot punch this paper type.”
“Interrupt copying is not available for this
size.”
“Cannot offset this paper size.”
[“Cannot group this paper size.”]
“Cannot staple this size.”
[“Cannot staple this paper size.”]
“Cannot punch this size.”
[“Cannot punch this paper size.”]
Procedure
Load transparencies onto the multi-bypass tray.
There is no paper loaded of a size that can be used in the currently selected mode.
Check the paper.
The orientation of the original and the selected paper are different. Change the
orientation of the original. If you press the [Start] key without changing the original,
copying will be performed at a 100% (1:1) magnification ratio.
Load paper of the size selected or change the selection for the paper size.
The orientation of the original and the selected paper are different. Change the
orientation of the original.
Remove the originals from the Document Processor, stack them together cleanly and
reset them in their current order back in the Document Processor.
Remove the originals from the Document Processor and reset them in their original
order back in the Document Processor.
Remove the originals from the Document Processor.
The selected paper type cannot be copied. Select a different type of paper.
The selected paper type cannot be stapled. Select a different type of paper.
The selected paper size cannot be hole punched. Select a different type of paper.
Interrupt copying is not possible. Use different originals or cancel the interrupt
copying operation and try to copy again later.
The selected paper size cannot be sorted. Select a different size of paper.
The selected paper size cannot be stapled. For more detailed information, refer to
the Operation Guide for your Document Finisher.
The selected paper size cannot be hole punched. For more detailed information,
refer to the Operation Guide for your Document Finisher.
Reference
page
3-4
——
——
7-23
——
——
——
——
——
——
——
——
——
——
——
