Part 2: Kit
In the loft, trim the heated water pipe
excess to length. Insert the remaining
plastic tube insert the end of the water
pipe and then push fit into the 15 mm elbow
fitting
(Fig.32)
.
Fit the bracket end trims onto the
brackets.
FITTInG ThE hoSE and
ShoWERhEad
Feed the flexible hose through the hose
retainer opening
(Fig.33)
so that it acts as
a retaining ring
(Water Regulations)
.
Screw the flexible hose to the bulkhead
(Fig.34)
or the outlet connector
(Fig.35)
and the other end to the showerhead. Make
sure the supplied washers are in place at
both ends of the flexible hose.
Place the showerhead into the holder and
check that it fits correctly.
Note:
The holder is slightly tapered and the
showerhead and hose will only fit from one
direction.
ImportaNt:
It is the conical end of
the hose which grips into the holder. The
showerhead will not fit in the holder without
the hose attached.
At this stage, disconnect the showerhead
and lay aside until the shower unit has been
commissioned.
Showerhead
Bulkhead
Washers
Fig.33
Fig.34
Showerhead
Outlet
connector
Washer
Fig.35
15 mm elbow
fitting
Pipework to mixing unit
(not supplied)
Heated
water pipe
(up riser rail)
Plastic
insert
Ceiling
Fig.32
