12
Basic Operation
Alarm On:
Indicates that the alarm is enabled.
INPUT Icon:
Indicates that the 3-digit value displayed is the Input Voltage.
OUTPUT Icon:
Indicates that the 3-digit value displayed is the Output Voltage.
LOAD Icon:
Displayed in two modes:
1. Displayed in conjunction with the % icon and 3-digit value to indicate the
load percentage.
2. Displayed in conjunction with KWH/Day and 3-digit value to indicate daily
power consumption.
3. Both the LOAD icon and Warning icon will flash to indicate an overload.
BATT Icon:
Displayed in two modes:
1. BATT icon (displayed in conjunction with % icon and 3-digit value) indicates
the Battery Capacity %.
2. BATT icon is shown with TEST icon to indicate self-test mode or control
mode.
% Icon:
Indicates units of %.
TEST Icon:
Displayed in conjunction with BATT icon to indicate that the UPS is
performing a self-test.
RUNTIME Icon:
Displayed in conjunction with the MIN icon and 3-digit value to
indicate Runtime in minutes.
MIN Icon:
Indicates units of minutes.
1. Displayed in conjunction with RUNTIME icon and 3-digit value to indicate
battery runtime in minutes.
2. Displayed in conjunction with the 3-digit value (reporting “LCD”) to indicate
the minimum brightness.
VWA Icon:
This is a multipurpose icon which indicates units of Volts, VA, Watts,
or Amps (V, VA, W, or A will be shown).
K Icon:
Displayed in conjunction with the W to indicate Kilowatts. It is also
used in conjunction with the WH and /DAY icons to indicate Kilowatt Hours per
Day.
H and /DAY Icons:
Displayed in conjunction with “K” and “W” icons to indicate
Kilowatt Hours per day (KWH/DAY).
Sensitivity Icon:
Displayed to set the AC input line sensitivity setting.
Sensitivity settings available are 100% (Normal = no delay), 50% (half delay),
and 25% (full delay).
18-05-315-933848.indb 12
7/9/2018 11:22:56 AM
