Owner’s Manual
Compact Table Saw - Folding Stand
Model Number: CTS-FS
Copyright SawStop, LLC
All Rights Reserved.
Published, October 2021
Updates of this manual may be available at www.SawStop.com
Page 1: ...Owner s Manual Compact Table Saw Folding Stand Model Number CTS FS Copyright SawStop LLC All Rights Reserved Published October 2021 Updates of this manual may be available at www SawStop com ...
Page 2: ... sure fasteners are tight and that the clamps and cradles are solidly attached to the frame and functioning properly Periodically inspect the stand for damage Place and use the stand on a solid level surface Place the stand in the working location before mounting the saw Never stand on or climb on the stand Turn off and unplug the Compact Table Saw before mounting on the stand or removing from the...
Page 3: ...s are inserted and mated to the square holes in the upper legs 4 Thread the eight lock nuts onto the bolts and then tighten Do not over tighten 1 Open the stand and then place on a solid level floor or solid level ground The stand is fully opened when the center cross brackets A will not allow the stand to unfold any farther Be aware of pinch hazards at the pivot points B of the assembly 2 Open th...
Page 4: ...mps are locked before using the saw 4 Close the front clamp A Close the rear clamp B The stand is now ready to use The cross plate with two cradles and one clamp is the front of the stand B the rear cross plate has one cradle and one clamp The front of the saw must face the front of the stand 3 With the Compact Table Saw turned off and unplugged place the saw on the stand with the frame in the cra...