28
Internal Battery Replacement
Under normal conditions, the original batteries in your UPS will last many years. See Safety section before replacing batteries. The
batteries are designed for hot-swap replacement (i.e. leaving the UPS ON), but some qualified service personnel may wish to
completely turn the UPS OFF and disconnect equipment before proceeding. It is suggested that you remove the batteries before
the installation process.
1
Remove the screws
A
which secure the front bezel.
2
Separate the front bezel
B
from the front panel.
3
Remove the battery connector snap covers. Save
these covers for reuse.
4
Disconnect the battery connectors
C
and remove the
screws
D
that secure the battery retention bracket in
place.
5
Remove the battery retention bracket
E
and remove/
recycle the middle battery pack
F
.
6
Remove/recycle the side battery packs
G
.
7
Replace the battery packs
F
and
G
.
8
Re-attach the battery retention bracket
E
.
9
Replace the screws
D
to secure the battery retention
bracket in place.
10
Connect the battery connectors
C
. Attach connectors
black-to-black, red-to-red, white-to-white and green-
to-green.
11
Reinstall the battery connector snap covers.
12
Replace the front bezel
B
.
13
Replace the screws
A
to secure the front bezel in
place.
1
13
2
12
4
9-10
5
7-8
6
7
A
B
C
D
D
E
G
G
F
201207113 933070.indb 28
9/17/2012 1:20:10 PM
