Triple S JAGUAR 20R, Owner'S Manual

Page: 14 / 60

location
.
9) switched to upper
the brake handle switched to lower location.
the brake handle (D, Figur
MENTAINENCE chapters for batteries charging].
the machine steer backward, or the machine will
Press brush button (B
tor (P). When the overloa
11
B
C
D
A
Figure 9
A
C
E
D
B
F
G
H I
L
M
N
O
P
Q
R
S T U
Figure 10

Brake unstuck - e

Brake locked
In some special cases, such as machine packing/unpacking,
machine fault etc., need to move the machine without drive
motor working, please manually set the brake to unstuck
status to move it.
To avoid any security risk, ensure to set the brake back to
locked status after machine movement.
MACHINE START AND STOP
Starting the machine
1. Prepare the machine as shown in previous paragraph.
2. Sit on the seat (L, Figure 10), insert the key switch (A) and turn
it to “ON”. If the green light (C) is on, the batteries are fully
charged for use. If the yellow light (E) or red light (D) is on,
batteries must be charged before operation. [Refer to
3. Lower the squeegee assembly to the floor.
NOTE
Make sure the squeegee assembly is lifted before
be stopped and LED screen show “Error”
information.
4. Lower the brush assembly to the floor.
NOTE
Make sure to turn off brush button before brush
assembly is lifted, and lift the brush assembly
before machine steers forward/backward.
5. ).
6. Depress the accelerate pedal (R), operate the machine
forward or backward by steering wheel (N) together with
forward-backward switch (H), you can adjust speed by speed
adjusting knob (I).
7. Adjust solution flow by solution adjusting button (G) base on
cleaning requirement.
8. You can charge your phone or pad through USB charging
port (M) when the key switch (A) is turned to “ON”.
9. Press the horn button (F) to warn people when necessary.
10. If necessary, press the emergency button for machine
emergency stop.
NOTE
The brush motor, vacuum motor, drive motor and
control circuit are protected by overload protec-
d protector trip, do not
reset it immediately without finding out the root
cause, and make sure the motor is cooling-off
before reset.
Stopping the machine
11. Loosen the accelerate pedal (R, Figure 10), the machine stops running.
12. Press brush button (B) to stop brush motor.
13. Lift brush assembly (T) by depressing the pedal (Q).
14. Lift squeegee assembly (U) by squeegee lifting/lowering lever (O), and a few seconds later the vacuum system will
be closed.
-