Triple S JAGUAR 20R, Owner'S Manual

Page: 19 / 60

16
reverse order of disassembly. After the blade repla
clean the filter screen (B), and then fix them back
USER MANUAL ENGLISH
B
C
A
Figure 20
SOLUTION FILTER CLEANING
1. Drive the machine to the flat ground.
2. Make sure the machine is off.
3. Empty the solution tank (optional step).
4. Take down the solution filter cover (A, Figure 18) to
to the
filter support (D).
NOTE
The filter screen (B) must be correctly
positioned to the housing of filter support
(D).
SQUEEGEE CLEANING
NOTE
The squeegee must be clean and its blades
must be in good conditions in order to get
good drying.
CAUTION
It is advisable to wear protective gloves
when cleaning the squeegee because there
may be sharp debris.
1. Drive the machine on a level floor.
2. Turn the key switch (A, Figure 19) to “OFF”.
3. Lower the squeegee (B) with the lever (C).
4. Loosen the knobs (D) and remove the squeegee.
5. Disconnect the vacuum hose (E) from the squeegee.
6. Clean the steel or aluminum squeegee, especially the
compartments (A, Figure 20) and the holes (B). Check
the integrity, cuts and tears of the front blade (B) and
rear blade (C), if necessary, replace them according to
procedures in the following paragraph.
7. Assemble the squeegee in the reverse order of
disassembly.
SQUEEGEE BLADE CHECK AND REPLACEMENT
1. Clean the steel or the aluminum squeegee, as shown in the previous paragraph.
2. Check that the edges (E, Figure 21) of the front blade (C) and the edges (F) of the rear blade (D) lay down on the
same level, along their length; if necessary adjust their height according to the following procedure:
•
Remove the tie rod (G), disengage the fasteners (M) and adjust the rear blade (D), then engage the fasteners (M)
and install the tie rod (G).
•
Loosen the knobs (I) and adjust the front blade (C), then tighten the knobs.
3. Check the front blade (C) and rear blade (D) for wear, cuts and tears; if necessary replace them according to the
following procedure. Check that the front corner (J) of the rear blade (D) is not worn; if necessary overturn the
blade to replace the worn corner with an integral one. If the other corners are worn too, replace the blade
according to the following procedure:
•
Remove the tie rod (G), disengage the fastener (M) and remove the retaining strip (K), then replace/overturn the
rear blade (D). Assemble the blade in the reverse order of disassembly.
•
Unscrew the knobs (I) and remove the retaining strip (L), then replace front blade (C). Assemble the blade in the
cement (or overturning), adjust the height as shown in the
previous step.
4. Connect the vacuum hose (A, Figure 22) to the squeegee.
5. Install the squeegee (B) and screw down the knobs (C).
6. If necessary, adjust the squeegee balance adjusting knob (D).
A
B
C
D
E
D
Figure 19