Triple S JAGUAR 20R, Owner'S Manual

Page: 21 / 60

TROUBLE-SHOOTING
The machine does not go
The machine does not work,
The motors does not work; no warning
F2 is brush motor overload protector (30A).
F4 is drive motor overload protector (30A).
rload protector (30A).
in the reverse
18
A
B
C
D
E
F
G
Figure 24
FUSE CHECK/REPLACEMENT
1. Turn the key switch (D, Figure 24) to “OFF”.
2. Disconnect the battery connect cable.
3. Unscrew the screws (C) on the control panel and then turn over
the PCBA to find the fuse (A and B).
4. Check/replace the fuses:
A)
F1 is the low-power circuit fuse (5A)
B) F3 is brush dismount fuse (20A)
5. After check/replacement is done, re-assemble
order of dismount.
6. Check or reset the motor overload protector.
E) F5 is vacuum motor ove
F)
G)
ACCESSORIES/OPTIONS
In addition to the standard components, the machine can be equipped
with the following accessories/options, according to the machine
specific use.
For further information concerning the above mentioned optional
accessories, contact an authorized retailer.
Accessories/Options
See “Parts List” section
1.
GEL/AGM batteries
2. Pads of different materials
Trouble Probable causes Remedy
light turns on (C9)
The battery connector is disconnected Connect the battery connector
The batteries are completely discharged Charge the batteries
red battery
capacity warning light turns on (C8)
The batteries level is too low Charge the batteries
- forward /
backward
The control circuit board fault Replace the control circuit board
The drive motor controller fault
Refer to “DRIVE MOTOR ERROR
INDICATOR INFORMATION”
The operator not on the seat Sit on the seat
Squeegee is not lifted during machine
goes backward
Lift the squeegee
The brush motor does not work
The control circuit board fault Replace the control circuit board
Brush motor overload
Use soft bristle brush that is
suitable for cleaning, and reset the
brush motor overload protector
Brush motor contactor fault Contact after-sales service
Brush motor carbon brush wearing Contact after-sales service
Obstacles prevent the brush rotating Clean the brush
The drive motor does not work
Drive motor trouble light turns on
Refer to “DRIVE MOTOR ERROR
INDICATOR INFORMATION”
Drive motor overload
Reset drive motor overload
protector and check drive
motor/circuit
The vacuum motor does not work
Vacuum motor overload
Reset vacuum motor overload
protector and check vacuum motor
Relay of vacuum motor fault Contact after-sales service
Control board fault
Replace the control board