Triple S JAGUAR 20R, Owner'S Manual

Page: 13 / 60

d +104°F (+40°C).
touch the ground slightly.
ith the ground, the front blade make good contact
the front blade touch the ground slightly.
ground, queegee blade make good contact with
If step 5 install the brush/pad but not
10
E
F
C
B
D
A
Figure 7
1. Insert key switch (40) and turn to “ON”.
2. Press the pedal (6) forward by foot to lift brush assembly (11) from the floor.
3. Rotate speed adjusting knob (42) in counterclockwise until the end.
4. Place the brush (A, Figure 5) or pad (B, Figure 5) center align with brush deck.
5. Press the pedal (6) backward by foot to lower down brush assembly (11). Sit on the seat, press the brush button (39)
and depress the pedal (23) slightly, the brush/pad can be assembled automatically. Repeat these steps until
brush/pad is installed.
6. successfully, please manually take the brush/pad down.
7. Depress the pedal (6) forward by foot to lift the brush assembly (11) from floor, press brush remove button (41) to
uninstall it automatically.
CAUTION!
Rotate the speed adjusting knob (42) to the minimum speed before depressing accelerate pedal (6) to
avoid the machine running too quickly when it is started. Make sure the brush/pad is installed correctly
before machine operating.
ADJUSTING THE BALANCE OF SQUEEGEE
1. Install the squeegee (13) and fasten the squeegee knob
(20), then connect the vacuum hose (19) to the squeegee.
2. Adjust the squeegee by squeegee adjusting handle (A,
Figure 7).
a)
If there is gap between the ground and middle section
of rear squeegee blade (B), adjust the knob (A) in
counterclockwise direction (F) until all section of rear
s
b) If there is gap between the ground and both end
section of rear blade(C and D), adjust the knob (A) in
clockwise direction (E) until all section of rear blade
w
SOLUTION TANK FILLING
1. Open the water inlet cover (E, Figure 8).
2. Filling water or solution suitable for work performance through the water inlet with filter. The solution
temperature must not excee
3. Don’t overfill the tank, refer to water level indicator (G) for the water volume.
WARNING!
Use only low-foam and non-flammable detergents intended for automatic scrubber applications.
Drive motor inspection
1. Turn the key switch (A, Figure 9) to “ON”
2. Depress the accelerate pedal (C) slightly then loosen it to
check if the machine can be steered forward and stopped.
3. To ensure the security, confirm if the machine can be
stopped immediately by pressing the emergency button (B).
Rotate the emergency button to reset it.
CAUTION
Climbing capacity of the machine must not
exceed 10%.
CAUTION
The brake of drive motor is unstuck when the
motor works normally, it locks when the motor
stops working.
F
E
D
C
B
A
G
Figure 8