TX7410 Operation Manual
22
For example:
1. The current display mode is DIR, and “DIR” is displayed on LCD, as shown in Figure4-5.
Figure 4-5 Direct display mode
2. Press SHIFT key, “SHIFT” at left corner is on.
3. Press DISP key, “
⊿
” or “%” is displayed on LCD, as shown in Figure 4-6.
Figure 4-6 Absolute deviation display mode
Note: Please refer to limit list setup for tolerance mode.
4.2.11 Comparator
Press SHIFT + COMP to turn on or off comparator.
After comparator is turned off, comparator indicator on panel is off, alarm doesn’t beep,
comparison result doesn’t output through HANDLER interface, EOM of measurement’s
ending signal doesn’t output, but AD shift signal IDX and trigger input TRIG are still valid.
After comparator is turned on, “COMP” is displayed on LCD.
Perform the following steps to turn on or off comparator function:
1.
Press SHIFT key, and “SHIFT” at left corner is on.
2.
Press COMP key, “COMP” is displayed on LCD, which means comparison function has
been turned on, as shown in Figure 4-7.
Figure 4-7 Comparison function on/off
4.2.12 Measurement setup
Perform the following steps to enter measurement setup page:
1. Press SHIFT key at test page, and “SHIFT” at left corner is on.
2. Press SETUP key to enter measurement setup page, as shown in Figure 4-8.
