Trinity Highway QuadGuard Elite M10, Product Description Assembly Manual

Page: 34 / 60

TrinityHighway.com 33 Revision C September 2021
8) Fender Panel Attachment
Starting at the Backup and working forward, assemble Left and Right Fender Panels as shown
in Figure 27.
Step 1. Place the Fender Panel so that the center hole of the rearward Diaphragm is lined
up with the approximate center of the slot in the Fender Panel.
Attach the Mushroom Washer Assembly as shown in Figure 27 but do not tighten at this
time. (This helps to balance the Fender Panel.)
Step 2. Slide the Fender Panel forward until the holes in the Fender Panel line up with the
holes in the forward Diaphragm.
Step 3. Use a drift pin to align the center hole of the Fender Panel with the center hole of
the Diaphragm.
Step 4. Attach the front of the Fender Panels to the next Diaphragm using two rail bolts
and large hex nuts per side. Use only the top and bottom holes; leave the center hole open
until the next Fender Panel is attached.
Important: Do not mix the 5/8” rail nuts (larger) with the 5/8” heavy hex nuts
(smaller) (Figure 26).
Figure 26
Rail Nuts are Oversize
HEX NUT 5/8
FLAT SCREW 5/8x5, G8
MUSHROOM WASHER
SPRING,1 1/4 OD x5/8x1 1/2
FLAT WASHER 5/8x1 3/4
RAIL BOLT 5/8
RAIL NUT 5/8
Figure 27
Fender Panel Assembly
1 1/4” [32 mm]
1 1/16” [24 mm]