Trinity Highway QuadGuard Elite M10 Wide, Product Description Assembly Manual

Page: 34 / 68

TrinityHighway.com 33 Revision A August 2020
Note:
Mushroom Washers lay flat against the Fender Panel as shown below. Mushroom Washer
Stand-off must be seated completely through slot (Figure 35).
Continue attaching Fender Panels until you reach Diaphragm No. 1 (Figure 36).
15) Belt Nose Assembly
a. Using 5/8X5” hex bolts, 5/8X1 3/4” flat washers, and 5/8” hex nuts, attach Fender
Panels to Diaphragm Hinge Plates on three places per side (Figure 37 and 38). Tighten
all fasteners.
b. Thread additional 5/8” nuts onto the 5/8X5” hex bolts. Slide 5/8X1 3/4" flat washers onto
bolts (three places per side). Adjust the nuts so the outside of the washers are even
with the Fender Panel humps (Figure 37).
c. Place Belt Nose over Diaphragm/Fender Panel attachment bolts.
d. Align holes in Belt Clamps with bolts and place onto bolts against belt.
e. Secure with 5/8X1 3/4” washers and 5/8” hex nuts in three places per side. Adjust Belt
Nose Assembly so belt height is 32.0” above grade. Tighten all fasteners.
f. Complete Belt Nose Assembly by attaching Belt to Nose Cylinder with 1/2X3” hex bolt,
1/2” washer, lock washer, and hex nut.
Figure 36
Diaphragm No. 1 & Cartridge Placement
Figure 35
FENDER PANEL
MUSHROOM
WASHER
CORRECT
INCORRECT
STAND-OFF
DIAPHRAGM #1
ME2
ME3
ME1 QEN