Trinity Highway QuadGuard Elite M10 Wide, Product Description Assembly Manual

Page: 33 / 68

TrinityHighway.com 32 Revision A August 2020
14) Fender Panel Attachment
Starting at the Backup and working forward, assemble Left and Right Fender Panels as shown
in Figure 34.
Step 1.
Place the Fender Panel so that the center hole of the rearward Diaphragm is lined
up with the approximate center of the slot in the Fender Panel.
Attach the Mushroom Washer Assembly as shown in Figure 35 but do not torque at
this time. (This helps to balance the Fender Panel.)
Step 2.
Slide the Fender Panel forward until the holes in the Fender Panel line up with the
holes in the forward Diaphragm.
Step 3.
Use a drift pin to align the center hole of the Fender Panel with the center hole of
the Diaphragm.
Step 4.
Attach the front of the Fender Panels to the next Diaphragm using two rail bolts
and large rail nuts per side. Use only the top and bottom holes; leave the center
hole open until the next Fender Panel is attached.
Note:
Do not mix the 5/8” rail nuts (large) with the 5/8” hex nuts (small) (Figure 33).
Figure 33
Rail Nuts are Oversize
5/8 RAIL NUT
5/8X5 G8 FLAT SCREW
MUSHROOM WASHER
1 1/4ODX3/4X6 DIE SPRING
5/8X2 RAIL BOLT
Figure 34
Fender Panel Assembly
1.25” [32 mm] .94” [24 mm]
Rail Nut Hex Nut