Page 2-2
3. Remove the locknuts from the four (4) Leveling Feet. Thread the leveling feet all the way
into the nuts welded in all four (4) corners of the scale lower frame (
see fig. 2-2
). Once
the leveling feet are installed thread the locknuts back onto the top side of the leveling
feet (hand tight).
Fig. 2-2:
Corner Detail
4. Before beginning installation into the counter it is recommended to perform an initial
check of the scale system. Set the scale base on the floor, level the scale and plug all
components into the control module. All the ports on the control module and cables are
clearly marked (
see
fig. 2-3
for System Block Diagram
). Place stainless steel platter
back onto the scale. Turn the scale on with the on/off switch located on the remote
keypad.
CONTROL MODULE
TRINER MODEL 600-E BAGGAGE SCALE - SYSTEM BLOCK DIAGRAM
Power Supply
KEYPAD MODULE
DISPLAY MODULE #1
DISPLAY MODULE #2
LOAD CELL CABLE, 15 ft LONG
1. Load Cell Cable terminated by 14-pin Centronics Male.
NOTES:
2. Keypad Cable terminated both ends by 9-pin DSUB Male.
KEYPAD CABLE, 12 ft LONG
DISPLAY CABLE (x 2), 12 ft LONG
3. Display Cables terminated at control box end by 9-pin DSUB Male
and terminated at display module end by 9-pin DSUB Female.
LOAD CELL
M
F
M
F
F
M
M
F
M
M
F
F
F
M
F
To
optional
serial
cable.
120-240 VAC
12 VDC, 800 mA
Fig. 2-3: System Block Diagram
5. Remove the stainless steel top and disconnect all cables from the control module. Place
the scale base in the location provided (bag well).
6. Center the frame in the bag well opening. Adjust the leveling legs so that the scale base
