9
Hand tighten the
NON-DRIVE END
Locking Nut
as tight as possible so the Taper Sleeve begins to
lock onto the Rotor Shaft.
Use a suitable “C” spanner to tighten the Locking
Nut one half of a turn (
180°)
Note:
If a “C” spanner is not available, tighten the
Locking Nut using a suitable pin punch and a light
hammer.
Align one of the slots in the Locking Nut with the
nearest tab on the Locking Washer.
Bend the tab into the slot in the Locking Nut to
secure.
Note:
It may be necessary to tighten the Locking Nut
slightly to achieve this.
Move to the
DRIVE END
.
Fit the strips of shim material to opposite sides of
the Bearing Housing between the Endplate and the
Bearing Housing as shown in
YELLOW
.
Note:
The details for the shim material are detailed on
PAGE 1.
Tab aligned and bent into slot
Hand tighten the
NON-DRIVE END
Locking Nut as tight as possible
Tighten the
NON-DRIVE END
Locking Nut a further
180°
Shims fitted
