11
Align one of the slots in the Locking Nut with the
nearest tab on the Locking Washer.
It may be necessary to tighten the Locking Nut
slightly to achieve this.
Bend the tab into the slot in the Nut to secure it.
FULLY TIGHTEN THE DRIVE END
MOUNTING BOLTS.
Ensure the fasteners are fitted as original!
Note:
A medium strength thread locker is recommended
for use on the mounting bolts.
Sling the Rear Roller as before.
Lift the Transport System back into place as
shown in
YELLOW
.
Secure the
FRONT
to positions using two
M16 x 35 Bolts and M16 Nordloc Washers.
Hand tight
ONLY
at this stage!
One side shown.
Lower the Transport System into its original
position. Align the holes in the Trailing Arms with
the Body.
Refit the remaining M16 x 35 Bolts and M16
Nordloc Washers. Torque
ALL
four M16 x 35
Bolts to
185Nm (137ft/lbs)
Note:
This torque figure is critical to ensure the
Transport System is secured correctly to the Body!
As before, sling the Mower around the Headstock
Link Pin.
Tab aligned and bent into slot
Lift to this position
Refit this Bolt
Torque M16 x 35 Bolts
to
185Nm (137ft/lbs)
Sling around Pin
