12
Lift the Mower until standing on its end.
Lower the Mower back down so that the
Headstock is facing
UPWARDS
as shown on the
RIGHT.
Note:
The Mower may require some assistance to move
past its tipping point.
USE EXTREME CAUTION DURING THIS
STEP!
Refit the Bearing Guard to the
NON-DRIVE
End
of the Mower as shown in
YELLOW.
Secure using the M12 Spring Washers and M12
Plain Nuts.
Fully tighten.
Refit the Key to the Keyway in the
DRIVE END
of the Rotor Shaft.
Note:
High Strength Retaining Compound is
reccomended to secure the key!
Apply Medium Strength Thread Locking
Compound to each of the Grub Screws.
Insert the Taper Lock Bush
(402-060-710)
into the
Gearbox Extension Pulley
(403-361-270)
Align the holes as shown.
Fit the Grub Screws loosely using the Holes
shown.
Note:
DO NOT
place a Grub Screw in the location
highlighted
RED
, this is only used for pulley
removal!
Reinsert Grub Screws into
Gearbox Extension Pulley
Lift to this
position
Lower to this
position
Refit the Bearing Guard
Refit the Key
