2
Remove the Rotor Bearing Guard from the
NON-DRIVE
end of the Mower as shown in
YELLOW
.
Place the Rotor Bearing Guard and fasteners to
one side.
Remove the Belt Guard from the Drive-end of the
Mower as detailed in the Operators Manual.
Remove the Belts as detailed in the Operators
Manual.
At the Rotor Pulley, remove the two Grub Screws
shown.
Reinsert one Grub Screw into the unused hole in
the Pulley.
Gradually tighten this Grub Screw.
As it is tightened, the Pulley will contact the
Bearing Housing and then begin to drive the Taper
Lock Bush off the Rotor Stub.
Remove Belt Guard
and Belts
Remove Grub Screws
Reinsert Grub Screw
Remove Rotor
Bearing Guard
