4
Lower the Mower back down so that the
TOP
of
the Headstock is now contacting the Ground and
the Rotor is facing
UPWARDS
as shown.
Note:
The Mower may require some assistance to move
past its tipping point.
USE EXTREME CAUTION DURING THIS
STEP!
Using suitable Lifting Equipment, support the
Rear Roller, shown in
YELLOW
.
Once supported, remove the two M16 x 35 Bolts
and M16 Nordloc Washers used to secure the
Trailing Arms to the Body near the Roller. One
side shown.
Note:
Take note of the hole position used near the
Roller, this will be needed to set the Mower back
to the same cut height later in this process!
Slacken the remaining two M16 x 35 Bolts.
Lift the Transport System to position as shown in
YELLOW
.
Then, remove the two M16 x 35 Bolts and M16
Nordloc Washers.
One side shown.
Remove the entire Transport System and place to
one side with the fasteners.
Using suitable Lifting Equipment, support the
Rotor.
Once supported, remove the four M16 x 50 Bolts
and M16 Spring Washers from each of the Rotor
Bearings.
One side shown.
Note:
Take note of the Rotor Bearing Grease Nipple
direction!
Lower to this
position
Sling Roller to
support
Lift to this
position
Then remove this Bolt
Then remove this Bolt
Sling Rotor to
support
Then remove these Bolts
