Trilithic 120 DSP, Operation Manuals, Page: 164 / 288

www.trilithic.com
Page III-14
120 DSP Operation Manual
Basic Signal Level Meter
120
Each test location will be tested against a channel plan and limit set that is configured using
the ViewPoint WFM Module.
The following information will be displayed below each location;
• Required Status - Each location will display its status with either of the following:
• Blank - This is displayed when the
location is not required and can be
tested more than once.
• Required - This is displayed when the
location is required and can only be
tested once.
• Required (+) - This is displayed when
the location is required and can be
tested more than once.
• Location Pass/Fail Indicators
- Each location
will display a pass/fail indicator as shown in the following section:
Channel Plans and Limit Sets created/modified on the 120
DSP can only be used in the Troubleshooting menu. Autotests
require ViewPoint Express or ViewPoint WFM Module Channel
Plans and Limit Sets.
You can retest any location that fails as many times as you
like but once a required location passes and only one test is
required, you are done with that location.