Seat & Post Assembly
1.
The seat comes disattached to
the seat post. Use the 6mm hex
wrench supplied in the box to
loosen the single hex bolt on the
seat post.
2.
You will loosen the bolt (1) far
enough so that the holding plate
(2A) can swivel 90 degrees (2B).
3.
With the seat upside down, drop
the post onto the seat mounting
bars (3A). The bottom plate will go
down between the two mounting
bars. Rotate the plate back 90
degrees (3B) and use the hex
wrench to tighten the bolt. Before
firmly tightening the hex bolt,
leave enough slack to allow you
to adjust the seat position after
you mount it on the Bikke.
4.
Insert the seat post into the
frame. There is a spring loaded
brass pin (4A) that secures the
seat in three preset riding heights.
The pin will face the front of the
BIKKE. Once you have inserted
the post to one of the preset
positions, secure it with the quick
release lever (4B). If the lever
seems too loose when closed,
use the adjustment finger nut on
the quick release lever to increase
the tension. When properly set
the lever requires a firm hand to
close.
5. The seat should look like the
photo to the right when properly
assembled and attached.
10
Summary of Contents for Bikke
Page 1: ......
Page 7: ...COMPONENT DESCRIPTION 7 ...