Trikke Bikke, Owner'S Manual, Page: 9 / 22

Handlebar Attachment
Before you can attach the handlebars it is
vitally important that you connect the throttle
control cable. On the bottom end of the
handlebar tube you will find what looks like
a telephone jack. Inside the steering tube on
the BIKKE where the handlebar inserts into
the quick release lever, you will find what
looks like a coiled phone cord. Pull the cord
out and attach it to the jack at the base of the
handlebar tube.
Next, make sure that the front wheel is turned
into its forward facing position with the brake
assembly facing forward. Check that the
coiled control cable under the frame is not
wrapped around the steering tube.
Fully insert the handle bar unit using the guide
pin on the back side of the handlebar tube to
insure that the bars are properly aligned with
the front wheel.
Once you have properly attached and
inserted the handlebars, use the quick
release lever (item 6 on page 7) to
secure the bars in their locked riding
position. If the quick release mechanism
feels too loose, use the two finger
nut adjustment screws to tighten the
release mechanism. It should require
a firm hand to completely close the
mechanism.
9