©
2012 Tridonic
Page 5 of 8
2.2 Programming the entire parameter list
All parameters must be newly set or checked at the time of initial programming.
To do this, proceed as follows:
Function Button
Display
1
Switch on the programming device
SMART
Programmer
Version 2.30
2
Go to the “Download/Program” menu item
<downld/progr>
3
Select the <downld/progr> menu
download all
4
Load all the stored parameters from the DSI-SMART (PTM)/basicDIM
ILD in the DSI-SMART Programmer. (The light is switched off
throughout this entire process. The DSI-SMART (PTM)/basicDIM ILD
switches back to automatic mode after data transfer has successfully
completed.)
download all
reading....OK
5
All the parameters are now stored in the programming device. Quit
this menu item
<downld/progr>
6
Go to the “Basic Parameters” menu item
<basic param>
7
Confirm. The adjustable parameter is then shown on the first line.
The current value (e.g. 65) can also be seen on the first line. Possible
settings are displayed on the second line.
light level: 65
1-100/max/man
8
If this value is to be modified, select it by pressing the “Select” button.
The asterisk in the top right hand corner indicates that the setting can
be modified.
light level: 65 *
1-100/max/man
9
Use the “Scroll” buttons to select the desired value.
light level: 70 *
1-100/max/man
10 Quit this menu item. The previously set value is retained.
light level: 70
1-100/max/man
11 Select the next parameter.
t-delay: 10 min
30s-60min/cont.
12 Press “Select” to make this parameter modifiable. (Example: currently
10min)
t-delay: 10 min*
30s-60min/cont.
13 Use the “Up/Down” buttons to set the new value (e.g. 20min).
t-delay: 20 min*
30s-60min/cont.
14 Quit this menu item.
t-delay: 20 min
30s-60min/cont.
15 Repeat this procedure until all the parameters have been set as
required. A list of all the parameters can be found in
Section 2.1: Adjustable parameters
16 When all parameters have been set, quit the <parameter> menu item
<basic param>
17 Go to <downld/progr>
<downld/progr>
18 Select the <downld/progr> menu
download all
19 Go to <programm all>
program all
20 Transfer all the stored parameters from the DSI-SMART Programmer
to the DSI-SMART (PTM)/basicDIM ILD. (The light is switched off
throughout this entire process. The DSI-SMART (PTM)/basicDIM ILD
switches back to automatic mode after data transfer has successfully
completed.)
program all
sending....OK
All the parameters are now stored in the DSI-SMART
(PTM)/basicDIM ILD.
