©
2012 Tridonic
Page 7 of 8
3. Monitoring
The following actual values can be monitored in the case of the DSI-SMART PTM and basicDIM ILD
4
:
Parameter
Value
Description
DSImon
0-255 / 0-100%
Current DSI value output by the DSI-SMART PTM/basicDIM ILD.
LUXmon
x.x lx
Current light level in lux measured by the DSI-SMART
PTM/basicDIM ILD.
Reading out actual values:
Function Button
Display
1
Switch on the programming device
SMART
Programmer
Version 2.30
2
Go to the “Monitoring” menu item
<monitors>
3
Select. The “DSImon” parameter is then shown on the first line.
DSImon: 0 0%
4
Select the parameter that is to be monitored. (e.g. LUXmon)
LUXmon: 0.0
In lx
5
Read out the currently measured value from the DSI-SMART
(PTM)/basicDIM ILD.
LUXmon: 50.0
Reading..... OK
4. Remote control
The remote control function makes it possible to switch the lighting off and/or start automatic lighting
control in the DSI-SMART (PTM)/basicDIM ILD.
Function Button
Display
1
Switch on the programming device
SMART
Programmer
Version 2.30
2
Go to the “IR-Remote” menu item
<IR remote>
3
Select. The “lamp off” function is then shown on the first line.
lamp off
4
Select the desired function (e.g. lamp to automatic)
lamp to auto-
matic
5
Press Send to transfer to the DSI-SMART (PTM)/basicDIM ILD.
lamp to auto-
sending….
5. System tests
Various function tests can be performed on the DSI-SMART PTM and basicDIM ILD in this menu
item
4
:
Parameter
Value
Description
PTM-status Short
circuit/OK Test whether there is a short-circuit in the momentary-action
switch lead
test start
start commissioning test
test end
stop commissioning test
Please note: The delay times of the sensor are temporarily set to the minimum adjustable time
during the commissioning test. This makes it possible to test this function quickly and
simply.
4
The Monitoring and System tests functions are only supported by the DSI-SMART PTM and
basicDIM ILD.
