©
2012 Tridonic
Page 6 of 8
2.3 Programming individual parameters
As well as programming the entire list of parameters, individual parameters can also be modified. To
do this, proceed as follows:
Function Button
Display
1
Switch on the programming device
SMART
Programmer
Version 2.30
2
Go to the “Basic Parameters” menu item
<basic param>
3
Select. The adjustable parameter is then shown on the first line. The
current value (e.g. 65) can also be seen on the first line. Possible
settings are displayed on the second line.
light level: 65
1-100/max/man
4
Select the parameter that is to be modified. (e.g. change bright-out
from “yes” to “no”.)
bright-out: yes
yes/no
5
Read out the currently set value from the DSI-SMART
(PTM)/basicDIM ILD.
bright-out: yes
reading…. OK
6
Press “Select” to make this parameter modifiable.
bright-out: yes *
yes/no
7
Use the “Up/Down” buttons to change to “no”.
bright-out: no *
yes/no
8
Program the change in the DSI-SMART (PTM)/basicDIM ILD.
bright-out: no *
sending.... OK
Repeat this procedure until all the parameters have been set as
required.
Please note: In the case of individual programming, the lighting is not switched off when
reading data in and out.
