![background image](http://html1.mh-extra.com/html/triax/s-hd-207/s-hd-207_operating-manual_1160896010.webp)
Operating the receiver
10
Operating the receiver
Switching receiver ON/OFF
1.) This receiver is optionally equipped with a low power standby circuit.
If this function is activated, the standby power consumption of the receiver is less
than 1W.
The function is switched ON or OFF in the menu SETTINGS/RECEIVER SETUP.
Low-Power Standby ON
– Switching on the receiver takes about 10 seconds (Display:
“boot”).
Low-Power Standby OFF
– Receiver switches ON immediately.
2.) The receiver is also equipped with the funcion
„
Auto-Standby
“.
This function can be activated or deactivated in the menu SETTINGS/RECEIVER
SETUP.
If
“Auto-Standby“ is activated, the receiver switches to Standby-Mode after 3 hours
running. Precondition: No timer is activated and no operations with the remote control
during this time.
You can switch on the receiver by pressing
OK
,
or by using one of the numeric buttons
1…0
. The last activated channel will be displayed (e.g. 0015).
The digital receiver is switched into standby mode by pressing
.
ATTENTION:
Only by pulling the mains adapter the receiver is disconnected from the power
supply completely.
TV & Radio mode
You can choose between the operation mode TV (viewing TV channels) and RADIO (listening
to radio channels) by pressing
RADIO
.
Volume control & Muting
The volume level can be adjusted by pressing
◄ ►
or
VOL
. The corresponding scale is
displayed on the screen.
Hint:
-
It is not possible to change the volume level while the menu is active.
-
The volume control only affects the audio output at the TV, VCR and AUDIO
ANALOG OUT ports of the receiver.
By pressing the
button you can totally switch off the audio output (muting). For switching
on again, simply use the same button.