TREVIL 5040 EASYFORM, Usage And Maintenance Manual

Page: 10 / 40

50xx Easyform-ed0811
¥
50xx EASYFORM 10
4. Operation
The machine described in this manual is a form finisher for garments
for the upper body.
The form finisher is designed for professional use only in:
•
Garment manufacturing industries;
• Large and small Industrial dry cleaners;
• Garment finishing industries.
The form finisher must be utilized only by qualified personnel, who
have been specifically trained on this type of machinery.
4.1. Safety precautions
During operation the appliance is under electrical ten-
sion:
• Do not operate machinery with partially exposed or frayed
wiring.
• Never permit water to come into contact with machine:
danger of electrical shock, short-circuiting and damage
to machine may result.
• Do not open the machine cabinet.
The appliance has various parts that reach extremely high
temperatures:
• Do not leave the machine unattended while it is on.
• Keep all flammable substances away from machine, to
avoid risk of fire.
• Do not open machine body.
• Do not replace cover and padding while machine is hot
(wait at least 2 hours after turning it off). Always check
the temperature of the form before proceeding to substi-
tute covers.
The appliance generates hot steam vapors - Stay clear of
steam reflex jet.
4.2. Before starting
Refer to figure 4.1
4.2.1. Model without boiler
1. Open the steam and condensate return valves.
2. Turn on the main power switch (1).
4.2.2. Model with boiler
1. Open the water feed valve.
2. Check that the boiler discharge valve is closed.
3. Turn on the main power switch (1).
4. Turn on the boiler switch (11).
5. Turn on the heating element switch (12).
6. Only for model 5055: turn on the second heating element (13).
This heating element may be kept off for energy saving if the
machine is to be used for few garments a day. If you realize that
the boiler needs too long to build up pressure, then you can
turn on the auxiliary heating element at any time.
4.3. Operation
Refer to figures 4.1 and 4.2
4.3.1. Settings
1. Adjust the pressure of the front and rear clamps so that they
hold the garment in place during the finishing cycle:
•
turn knob (4) clockwise to reduce the pressure;
• turn knob (4) anticlockwise to increase the pressure.
2. Adjust the blowing strength according to the garment: move
lever (5) t or - to increase or decrease blowing
strength.
4.3.2 Pressing
1. Use buttons (A) on the control panel to choose the cycle most
suitable to the garment to be finished.
2. Position the garment on the form and adjust shoulder width by
means of knob (9).
3. If needed, change the shape of the bag using the strings.
4. Close the front and rear clamps (8 and 7).
5. Insert sleeve expanders (3) and close any vents with manual
vent clamps (2).
6. Step on the START pedal (6) to start the finishing cycle.
WARNING - The general warning light (14) indicates that
one of the safety protections has tripped. Should it turn on
during usage, turn off the appliance immediately and report to
a service center.
4.5. Upon terminating work
4.5.1. Model without boiler
1. Turn off the power switch (1) and the switch installed on the
mains.
2. Close steam and condensate return valves.
4.5.2. Model with boiler
1. Turn off the power switch (1) and the boiler switches (11-12-
13).
2. Turn off the switch installed on the mains.
3. Close the water feed valve.
Operation