12
-
During operation, the product will automatically switch on and off periodically to maintain a constant
level of humidity in the environment.
-
After use press the POWER button, then unplug the unit from the power outlet. Do not leave the plug
inserted unnecessarily.
-
If you turn off the appliance, wait at least 3 minutes before switching on again, in order to protect the
compressor from damage.
HUMIDITY REGULATION
Humidity can be set between 40% and 80%.
-
Press SETTING button on panel (2). On display a number flashes; it indicates humidity currently set.
-
To change setting press SETTING button until reaching the desired value.
-
Wait 5 seconds without pressing any key.
-
During operation, the product will automatically switch on and off periodically to maintain a constant level
of humidity in the environment.
TIMER
Product has a 24 hours timer
-
Press TIMER button on panel (2). On display appears “00”.
-
To set timer, press TIMER button until reaching the desired time.
-
Wait 5 seconds without pressing any key. Appliance will automatically switch off after the hours set.
DEFROST
When the dehumidifier works for too long or it is used in environments with low room temperatures, the
antifreeze function (Defrost) it may work. This function prevents freezing of the evaporator located inside the
product, when it tends to freeze, defrost function turns off the device periodically detaining dehumidification.
WATER DRAINAGE
When the unit collects moisture from the environment, the water can be discharged in the water tank (5), if
the container is correctly mounted in its housing, or it can be drained continuously.
Continuous drain
If you want to operate the dehumidifier for a long time in the same environment, often
without having to empty the container, you can drain the water continuously through a
plastic tube with an inner diameter of 10mm (not included).
Follow the steps below:
-
Remove water tank (5) and insert the plastic tube on the water outlet located up-left
in the water tank space; then install the water tank (5) again.
-
Bring the plastic tube into a drainage container, taking care to keep the pipe always
facing down.
CAUTION
: whether you operate the unit in continuous drain mode or not, always place
the water tank (5) in its housing, otherwise the product will not work.
EMPTY THE WATER TANK
The red light " FULL" on the control panel (2) indicates that water container is full or not
installed correctly. In this case, remove water tank (5), remove the water and reassemble it
correctly in place.
CAUTION: the water collected in the tank can be used as distilled water for ironing.
Do not drink the exhausted water for any reason, and/or use it for another purpose.
AIR FILTER
Unplug unit from the electrical outlet before pulling out the filter.
Mounted to the air inlet grill (4) is located a filter that purifies the air coming out. If you use the product on a
regular basis clean the filter every 2 weeks. To do so, remove the grill by pulling it up. Wipe with a damp
cloth or wash with warm water. In any case, let it dry completely before installing it back.
