TRENDnet TPE-TG44ES, User Manual

Page: 14 / 30

© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-TG44ES
12
3. Review the settings. Click Apply to save the settings.
By default, queue configuration can be found at the bottom of the page, queue 0 being
the lowest priority and queue 3 being the highest.

1-7 – Indicates the 802.1p CoS tag values, 1 being the lowest and 7 being the
highest. Based on the priority tag value identified on the incoming frame, the
frame will be assigned to the specified queue assigned for the priority tag
value. This can be adjusted accordingly however default settings should be
sufficient.

Weight – The weight value indicates the queue priority value 1 being the
lowest and 32 being the highest. The higher the weight value assigned to a
specified queue, the higher the amount of packets from that queue are sent
out and processed before other lower priority queues. This can be adjusted
accordingly however default settings should be sufficient.

Strict Priority - Using this scheduling method, the port transmits all frames out
of higher priority queues before transmitting any from the lower priority
queues.

WFQ (Weighted Fair Queuing) – Using this scheduling method, the port
transmits a set number of bits from random queues, in a round robin fashion,
so that each has a chance to transmit traffic.
Storm Control
Configure Storm Control
Broadcast Storm Control
The switch can set rate limits on broadcast, multicast, and unicast (DLF) traffic and drop
traffic once the configured rate threshold is reached. This feature can be useful more
specifically for broadcast storms.
1. Log into your switch management page (see “ Access your switch management page ”
on page 6).
2. Click on Broadcast Storm Control.
3. Review the settings. Click Apply to save the settings.

Broadcast – Click the drop-down list and select the speed threshold for
broadcast traffic which will be applied to the switch on all ports.

Multicast – Click the drop-down list and select the speed threshold for
multicast traffic which will be applied to the switch on all ports.

DLF (Destination Lookup Failure) – Click the drop-down list and select the
speed threshold for unicast (DLF) traffic which will be applied to the switch on
all ports.