10/100 Fast Ethernet Switch User’s Guide
Unpacking and Setup
11
Power on
TE100-S44
The TE100-S44 Switch can be used with AC power sources 100 -
240 VAC, 50 - 60 Hz. To turn the Switch on, plug one end of the
power cord into the AC power connector of the Switch and the
other end into the local power source outlet. The Switch’s power
supply will adjust to the local power source automatically and may
be turned on without having any or all LAN segment cables
connected.
TE100-S88
The TE100-S88 Switch can be used with AC power sources 100 -
240 VAC, 50 - 60 Hz. The power switch is located at the rear of the
unit adjacent to the AC power connector and the system fan. To
turn the Switch on, press the power switch to the on or “1”
position. The Switch’s power supply will adjust to the local power
source automatically and may be turned on without having any or
all LAN segment cables connected.
LED Indicators
After the switch is turned on, the LED indicators should respond
as follows:
♦
All of the LED indicators will blink momentarily. This
blinking of the LED indicators represents a reset of the
system.
♦
The FDX/Col LED indicators blink from
yellow
to
green
.