TrendCommunications AuroraPlus, User Manual, Page: 175 / 226

Testing on Analogue Lines with
Aurora Plus
Issue 5 - 04/01 8-1
Testing on Analogue Lines with
Aurora Plus (Optional)
This chapter describes how to use
Aurora Plus
to make calls
and test on analogue networks. Also described is how to
perform a 40kHz Test to measure signal loss.
Note
Analogue is sometimes referred to as 'POTS' (Plain Old
Telephone Service).
Preparing Aurora Plus for Analogue Lines
• Set the ISDN ANALOG/POTS Switch to the
ANALOG/POTS position.
• Place the S/U Switch in the DOWN position.
• Switch
Aurora Plus
off and on, using the
CHARGE/BAT Switch, to re-initialise the unit and
apply the settings.
• Connect the two 4mm 'banana' plugs to the line
directly or via the 'crocodile' clips supplied.
The Analogue Main Menu is displayed:
Note
This menu is shown only when you have purchased the
analogue feature for your
Aurora Plus
. On battery units which
do not have analogue testing ability, when you select
analogue mode the 40kHz Generation Test screen is
displayed. For details, see later in this chapter.
8
Chap08.P65 01/05/01, 09:16 1