TrendCommunications AuroraPlus, User Manual, Page: 124 / 226

Trend
Aurora Plus
User Guide
5-4 429850
Choose
CONFIG
.
Aurora Plus
checks the line and displays a results screen similar
to the following:
A tick (
✔
) is displayed against valid configurations for the
line. A cross (
✘
) is displayed against invalid configurations.
If any protocol tested passes the configuration test with a
Point-to-Point line type, the Point-to-Multipoint test is not
performed and
?
is displayed on the screen.
Automatically configuring the line under test
To automatically configure
Aurora Plus
, key in the number
associated with a valid configuration. Using the example
above, you could input
4 to automatically configure
Aurora Plus
for ETSI Point-to-Multipoint.
Service Check: Determining Available Services
+
The Service Check determines the ISDN services subscribed
to on the line under test, and tells you which ones are
available.
You can perform a Local or a Remote Service Check:
Local Service Check
This tests the acceptance of calls
at the device
Aurora Plus
is
connected to - for example, your
local exchange.
Chap05.P65 01/05/01, 09:11 4