Trek DOMANE SLR 2017, Service Manual

Page: 9 / 28

1 INSTALLING THE ADJUSTABLE REAR ISOSPEED DECOUPLER AND SEATMAST
7.
On the non-drive side, insert the other pivot bolt
assembly from step 3 through the bore hole and
thread it into the IsoSpeed axle.
8.
Insert 5 mm Allen keys into both pivot bolts and
slowly turn each clockwise. Turn only until snug.
Do not over-tighten.
mm
5
mm
5
9.
Hold the non-driveside pivot bolt with the Allen
key (8a). Using a torque wrench, tighten the
driveside pivot bolt by turning it towards the
front of the bike to 8 Nm maximum (8b). Turn
until the wrench 'clicks' to ensure proper seating
and tightness.
8a
8b
N m
8
10.
Repeat the tightening process with the torque
wrench on the non-drive side.
N m
8
11.
Remove excess
grease with a
cloth. Align the
Rear IsoSpeed
cover, drive-side,
and snap into
place. Repeat
for the Rear
IsoSpeed cover,
non-drive-side.
NOTE
A correctly installed
seatmast moves freely.
If it does not, reinstall
and make sure that all
hardware is installed
correctly.
5