Trek DOMANE SLR 2017, Service Manual

Page: 22 / 28

5.
Install the front of the mudguard at the bottom of
the seat tube with the included fastener. Do not
fully tighten.
6.
Attach the rear wheel. Adjust the struts to the
appropriate length (6a) so that the mudguard is
centred and has enough clearance over the tyre
to prevent rubbing (6b).
6a
6b
7.
After finalising the position of the mudguard,
remove the rear wheel and tighten the brake arch
or seatstay bridge adapter fastener to a maximum
of 5.2 Nm.
N m
5.2
8.
Tighten the struts to a maximum of 3 Nm.
N m
3
9.
Finally, test the bike on the ground and loosen and
tighten the wheel closure system. Then check for
interference between the wheel and other parts
of the bike.
6 INSTALLING MUDGUARDS
18