Trek DOMANE SLR 2017, Service Manual

Page: 15 / 28

TOOLS AND MATERIALS REQUIRED
• Fork
• Compression ring
• Lower bearing
• Headset bearing • Compression plug
• IsoSpeed top cap
• IsoSpeed head tube cover
1.
Install the Front IsoSpeed head tube cover. Make
sure that the Front IsoSpeed decoupler is aligned
with the cover.
2.
Place the lower bearing over the steer tube (2a)
and pass the steer tube up through the head
tube (2b). Slide the headset bearing and then the
compression ring down onto the steer tube and
into the top of the decoupler (2c).
3.
Slide the IsoSpeed top cap over the steer tube.
2a
2b
2c
3
ISOSPEED TOP CAP
HEADSET
COMPRESSION
RING
HEADSET BEARING
DECOUPLER
HEAD TUBE
STEER TUBE
LOWER BEARING
4.
Install the Front IsoSpeed lower cover by wrapping
it around the head tube, starting on the left side
and using your thumb to press it into place.
This gap will
close after
installation of
the spacers
and stem, and
compression of
the assembly.
5.
Reinstall the spacers, stem and headset top cap.
Confirm that the compression plug is properly
installed in the steer tube and tightened to a
torque of 10 Nm (5a). Tighten the top cap
screw to 4 Nm (5b).
Finally, tighten the stem’s steer tube clamp screws
to the torque specified by the stem manufacturer.
5a
5b
N m
10
N m
4
3 INSTALLING THE FORK
11