www.traxontechnologies.com
©2019 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U.
PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
12/19 V2.0
15 of 23
2.3 On-Site Installation
•
DO NOT attempt installation in wet or severe weather conditions.
•
DO NOT leave and expose any Allegro Dot M/L, Pixel Distributor or LED
Engine unconnected under wet/raining or snowing environment.
•
Ensure all the cable connectors of Allegro Dot M/L are removed from the
Pixel Distributors before installing.
•
DO NOT pull on cable of Allegro Dot M/L. IP failure induced by stressed/
damaged cables during or after installation will not be under warranty by
Traxon Technologies.
•
ALWAYS keep the cables protected from sharp objects and ensure no
damage is generated on the cable.
•
Failure to keep Allegro Dot M/L within the operating temperature range of
-30°C to +60°C (+50°C for North America), -22°F to +140°F (+122°F for
North America), and storage temperature range of –40°C to 70°C (–40°F
to 158°F) will void the product’s warranty.
2.3.1
Mounting LED Engine
1. Fix LED Engine on top of Pixel Distributor with included M4 screws.
NOTE: Keep adjacent LED Engines and Pixel Distributors a minimum 150mm (5.91”)
apart for better heat dissipation.
FIG.14: Mounting LED Engine on top of Pixel Distributor
LED Engine mounts
on top of the Pixel Distributor
M4 × 8mm × 4
(Included)
(Not included)
M5 anchor bolts
(LED Engine is ordered
separately)
Mount Pixel Distributor
with connectors facing down
≥
150mm/5.91”
clearance
≥
150mm/5.91”
clearance
≥
150mm/5.91”
clearance
≥
150mm/5.91”
clearance
≥
150mm/5.91”
clearance
≥
150mm/5.91”
clearance
2. Mount the Pixel Distributor with 4 × M5 Anchor Bolts (not included). Recommended
orientation is with connectors facing DOWN (see above diagram).