Installation
(for qualified installers only)
7
Travis Industries
4 0 2 0 8 1 2
9 3 5 0 8 1 1 0
Fireplace Placement Requirements
Minimum Framing Dimensions
The 1” stand-offs along the sides and rear, the 1” clearance requirement around the sides and back,
and the 7-1/4” stand-offs on the top of the fireplace separate the fireplace from combustible materials
(e.g.: combustible framing members, plywood, sheetrock, paper-backed insulation). The stand-offs
may contact the framing members but no material may be placed between the stand-offs or into the
required 1” clearance to the sides and back.
This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance
produces when determining a location.
84-1/2" Min.
AA
AA
AA
AA
A
AA
AA
AA
AA
A
A
AA
AA
AA
AA
AAAAA
AAAAA
AAAAA
A
AAAAA
AAAAA
AAAAA
A
AA
AA
A
A
AA
AA
AA
AA
AA
AA
AA
AA
44-1/4"
20-1/2"
46-3/4"
NOTE: if venting directly to the rear, make sure
there is a min. 12" space centered behind the
fireplace. The firestop included with this fireplace
requires a 14" tall by 12" wide opening.
3" Clearance Min. Above Vent
The center of the vent is a minimum 70-1/2"
above the base of the fireplace (includes 24"
min. rise before elbow - see the section
"Horizontal Termination Requirements")
2" Clearance Min. to
the Sides of Vent
The fireplace enclosure
must not be less than
84-1/2" above the base
of the fireplace.
Top Vent Configuration
1" Clearance Min.
Below Vent
AAAA
AAAA
AAAA
A
AAAA
AAAA
AAAA
A
A
AA
A
A
A
AA
A
46-3/4" Min.
44-1/4"
20-1/2"
46-3/4"
NOTE: if venting directly to the rear,
make sure there is a min. 13" space
centered behind the fireplace.
3" Clearance Min. Above Vent
The center of the vent is 34-
1/4" above the base of the
fireplace (see the "Rear Vent
Configuration")
1-1/2" Clearance Min.
to the Sides of Vent
and Below Vent
The fireplace enclosure
may be framed over
the top stand-offs
(applies to the Rear
Vent Configuration
only).
Rear Vent Configuration
•
Fireplace must be installed on a level surface capable of supporting the fireplace and vent
•
Fireplace must be placed directly on wood or non-combustible surface (not on linoleum or carpet)
•
Due to the high temperature of the fireplace, it should be located out of traffic and away from furniture
and draperies.
