Travis Industries Endeavor, Manual

Page: 6 / 190

Travis Industries, Inc.
Model: Endeavor
Report Number:0028WS062E
INDIVIDUAL RUN SUMMARIES
Run 1 -
Test procedures followed to produce a high burn rate with a primary air setting of
fully open. Observed burn rate was calculated at 5.06 kg/hr. Emissions results
were calculated using particulate sampling from kindling, start-up fuel, and test
fuel load combined (cold to hot). Burn rate, and efficiency were calculated using
data from the test fuel load only (hot to hot). An error occurred in calculating
startup fuel weight, this caused the startup fuel weight to be out of tolerance and
the test to be terminated 0.1 pounds too early.
Due to this anomaly, run 1 was determined to be invalid for inclusion in the
weighted average.
Run 2 -
Test procedures were followed to produce a medium high burn rate with a
primary air setting of 0.297” (19/64”) open. Observed burn rate was calculated at
1.69 kg/hr. Emissions and efficiency results were calculated using a hot to hot
burn cycle, a coal bed generated by the high burn conducted in test one was used.
Due to errors that occurred during run 1, validity of run 2 was in question. It was
determined that there was enough cause to invalidate the test, results were omitted
from the weighted average.
Run 3 -
Test procedures followed to produce a high burn rate with a primary air setting of
fully open. Observed burn rate was calculated at 4.86 kg/hr. Emissions results
were calculated using particulate sampling from kindling, start-up fuel, and test
fuel load combined (cold to hot). Burn rate, and efficiency were calculated using
data from the test fuel load only (hot to hot). No sampling anomalies occurred,
this test run was determined to be valid for inclusion in the weighted average.
Run 4 -
Test procedures were followed to produce a low burn rate with a primary air
setting of full closed. Observed burn rate was calculated at 1.11 kg/hr. Emissions
and efficiency results were calculated using a hot to hot burn cycle, a coal bed
generated by the high burn procedure was used. No sampling anomalies
occurred, this test run was determined to be valid for inclusion in the weighted
average.
Run 5 -
Test procedures followed to produce a high burn rate with a primary air setting of
fully open. Observed burn rate was calculated at 5.13 kg/hr. Burn rate, was
calculated using data from the test fuel load only (hot to hot). No sampling
occurred during this test, it was conducted to generate a coal bed for test number
6.
Run 6 -
Test procedures were followed to produce a medium high burn rate with a
primary air setting of 0.50” (1/2”) open. Observed burn rate was calculated at 1.83
kg/hr. Emissions and efficiency results were calculated using a hot to hot burn
cycle, a coal bed generated by the high burn conducted in test one was used. No
sampling anomalies occurred, this test run was determined to be valid for
inclusion in the weighted average.
Page 6 of 186