ENGLISH
90
www.trapp.com.br
Air filter
Motor will not run properly with dirty air filter.
Frequently clean the filter, preferably with
compressed air. See motor manual.
To clean air pre-filter
The pre-filter must be free from dirt to avoid
damage to the motor due to overheating. Clean
with compressed air or wash in running water
with mild soap.
Useful Suggestions
Some problems may occur during the use of the shredder. Find some suggestions to solve them below:
Problem
Probable cause
Solution
Shredder
jamming
Excessive intake/feeding. Organic
material accumulates inside the
machine.
Turn shredder off. Remove upper output device,
open cover, remove excess of material from inside
the machine. Close cover, replace output device,
turn shredder on, wait for motor to reach maximum
revolution and get back to work. Control machine
intake/feeding.
Low production
1. Insufficient feeding.
2. Machine revolution below
specification.
3. Humid product.
1. Maintain continuous feeding, yet not
overfeeding which may cause shredder to jam.
2. Check whether TDP rpm is below 540 rpm.
3. Shred dry material only; humid products may
block output device.
Irregular cut
1. Cutting blades need sharpening.
2. Worn counter cutting blade.
1. Sharpen cutting blades as indicated in “Sharpen
and Replace Blades”.
2. Do as item “Check Blades”.
!
ATTENTION!
Use
TRAPP ORIGINAL
PARTS.
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur
due to the use of non-
original parts.
