ENGLISH
79
www.trapp.com.br
Checking battery
Remove closing protection (1) and loosen battery
securing bar (2). Remove battery from base (3),
check for charge in the viewer.
3
1
2
A
B
1
A
B
1
Note:
When replacing battery on the
base, make sure to properly connect
cables.
O
Red cable: (+) Positive
O
Black cable: (-) Negative
Attention!
If equipment is not used for more than 30
(thirty) days, you may run out of battery.
To prevent corrosion and loss of power
during long storage, disconnect battery
cables.
Disconnected cables must not get in
touch with battery terminals.
Belt Adjustment
Frequently check belt pressure. The belt is
located under the side guard. Unscrew guard
to check belt pressure. If necessary, adjust it or
replace it. When belt pressure is not enough,
its life is compromised.
Belt pressure for shredders TR-600E and
TR-600G is adjusted through the stretching
roll - under belt side guard.
To start the motor, lever (1) must be in position
(A) when the motor reaches maximum
revolution; slowly unlock lever to position (B).
Do not operate shredder without belt
protection guard.
3
1
2
A
B
1
A
B
1
3
1
2
A
B
1
A
B
1
