ENGLISH
82
www.trapp.com.br
Operation Instructions
When using the equipment
Check if rotation direction is correct.
Only shred wood and plant waste of proper
dimensions.
Wear proper clothes and safety equipment.
Make sure there is enough fuel in the tractor to
prevent an unplanned stop.
Only use shredder in safe conditions, well lit
and ventilated areas.
Push small material with long pieces of wood.
Small wood fragments must be slowly pushed,
longitudinally, to prevent chips from being
thrown against the operator.
Check whether machine is properly
connected.
The equipment must rest safely on the ground.
To avoid overloading TDP, shredder must be
parallel to the ground.
Blades must be sharp.
Check whether output device is properly
assembled and in the right direction.
Properly secure and adjust counterblade.
Check for the presence of tools or objects on
motor or equipment, mainly inside the funnel.
Check for people, pets or objects near the
area.
Atenção!
Unless when maintaining, do not remove
safety devices, protection covers or
collectors. When removal is necessary,
stop the motor, handle carefully and
reassemble properly before using the
equipment again.
To prevent major accidents, do not put
your hand inside the funnel.
Note:
If equipment is properly prepared,
start the motor. Wait for it to reach
maximum revolution and start
working.
Keep diesel or gasoline motors
running for some minutes to reach
normal working temperature.
Do neither start nor leave a diesel
or gasoline motor running in closed
environments, with no ventilation.
Exhaust gas contains carbon
monoxide, an odorless and lethal
gas.
Turning the shredder On TR-600T
When all preparation steps are done, the machine
will be ready for use.
Tractor discharge power must be 540 rpm.
Connecting the crusher TR-600G
Make sure there is oil in the crankcase and
correct level.
Check for gasoline in the fuel tank.
Gently pull the retractable starting cord until
meet resistance, and then pull it sharply.
Repeat until the motor starts.
Let the motor warm up for a few minutes.
Operate the throttle and start working.
To turn off the motor. Turn off the motor
specified key.
Note:
for further information on operation please refer
to the engine manual.
