Chapter 4, Configuring Administrative Settings
52
TR-WMX-3.5 Betriebsanleitung für Teilnehmergeräte
4.4.2 Enabling or Disabling Web, SSH, and Telnet Access
Using the Administrative Settings page, you can enable or disable Web access, SSH
access, and Telnet access to the TR-WMX-3.5.
If you disable Web access, you will not be able to access the TR-WMX-3.5 using a browser.
If you disable SSH access, you will not be able to access the TR-WMX-3.5 via an SSH
session.
If you disable Telnet access, you will not be able to access the TR-WMX-3.5 using a
Telnet session.
To enable or disable Web, SSH, and Telnet access to the TR-WMX-3.5, use the following
procedure.
1.
To enable or disable Web access to the TR-WMX-3.5, click the down arrow next to
Enable Web Access and select Enable or Disable from the drop-down list.
2.
To enable or disable SSH access to the TR-WMX-3.5, click the down arrow next to
Enable SSH Access and select Enable or Disable from the drop-down list.
3.
To enable or disable Telnet access to the TR-WMX-3.5, click the down arrow next to
Enable telnet Access and select Enable or Disable from the drop-down list.
4.
Click the Apply button to save your changes. Then either:
–
Click the Reboot button on the next page that appears to apply the settings and
reboot the TR-WMX-3.5 at this time.
–
Change any other configuration settings you want to modify. When finished,
apply all the new and reboot the TR-WMX-3.5.
4.4.3 Enabling or Disabling the Status LEDs
Using the Administrative Settings page, you can enable or disable the 10 status LEDs on
the rear panel of the TR-WMX-3.5. By default, the LEDs are configured to be ON. This
means they show the status of the TR-WMX-3.5 as described in Table 1-5 on page 22. If
the TR-WMX-3.5 will be installed in a location where the LEDs cannot be observed, you
can disable them and rely on the status screens described in Chapter 3 to assess the
status of the TR-WMX-3.5.
To enable or disable the status LEDs on the TR-WMX-3.5, use the following procedure.
1.
Click the down arrow next to Status LEDs and select Enable or Disable from the
drop-down list.
2.
Click the Apply button to save your changes. Then either:
–
Click the Reboot button on the next page that appears to apply the settings and
reboot the TR-WMX-3.5 at this time.
–
Change any other configuration settings you want to modify. When finished,
apply all the new and reboot the TR-WMX-3.5.
